The inside of the flute tube should be scrubbed frequently, because the breath blown into the "blow hole" from the lips also carries some saliva, which will condense into a layer of black dirt after a long time. Some students think that with this layer of black dirt in the flute pipe, the sound produced by the flute is more beautiful and pleasant. In fact, this is wrong. It not ...

For flute beginners, the mouth shape is very important. Due to the wrong mouth shape and improper use of breath, the flute is pressed hard on the lips, so that the sound is mixed, or even no sound can be played. The correct way is to blow the breath to the inner side of the flute. Solution: Practice the correct mouth shape in front of the mirror, place the blow hole of ...

Today I will share with you how to make a flute. First choose the bamboo material. Generally speaking, it is necessary to choose old, solid and dry bamboo, followed by small bamboo joints (not too tight), round and flat surface, and the thickness of the two ends is not much different. Once selected, cut into sections according to the length of the flute. If the bamboo body is no...

Compared with the flute’s “extra-long tone” practice, the suona is the easiest to master. This is because the suona is pressed by a copper sheet, and the lips are easy to control, while the flute completely relies on the lips to exert force. In addition, all the air blown on the suona can be blown into the wall of the pipe, while the flute is vibrating with air, and some of the blown gas escape...

Flute lovers all know that if the flute is played for a long time, especially in winter, the air outside is cold, and the gas breathed into the flute pipe is hot, which will form water vapor, which will make the flute membrane wet and wet, which is the most hurtful to the player. Brain thing. Especially in the performance, the film suddenly became wet in the middle, and the flute could not be p...

What tools do you need to make a flute? (1) Choose a small saw or knife capable of cutting bamboo; (2) A drill or thick iron wire (burning red) that can drill holes (holes) is used for drilling; (3) Small sharp knives for digging holes (ordinary small sharp knives can also be used); (4) Pencils and millet Dachi (5) Choose a long knife that can penetrate t...

Common flute size ratio table Note: (1) The distance between the holes must be calculated from the center of each hole, not from the edge of the hole. (2) Dimensions are in millimeters, such as 15mm. ...

The flute is a simple musical instrument that many friends can make, and it can be made with just one piece of bamboo. One of the characteristics of bamboo is that it is easy to change, especially in summer when the temperature is high, the bamboo tube is easy to rise after being heated, so that the diameter of the "inside the tube" is reduced, and the flute sound will increase....

Beginners should stick the flute film a little tighter, so that they can easily play the flute. Sometimes, because the flute film is too loose, what should I do? You can repeatedly use the "mouth" to face the flute membrane and slowly blow with hot air, and then rush to blow with cold air against the flute membrane, so that it can gradually return to normal after repeated repeti...

When the flute lovers are playing the flute, due to the improper control of the "wind of the mouth", the damper ", the misalignment of the lips and the blowing hole", etc., it is easy to make a "hissing" or "Buddha, Buddha, Buddha" air leakage sound. , are called noise. Noise is a great hindrance to the timbre, and it is easy to get used to it. It is often the most likely to mak...