When we bought a flute, after a period of practice, what should I do if the flute itself is not allowed? How should I debug?

1. Principle of flute sound height

The height of the flute is related to the size of the flute's sound hole, the length of the flute body, and the thickness of the inner bore. The flute body is thin, the sound holes are small and the hole is close to the hole, and the sound is high;

2. The overall sound of the flute is high

In fact, most of the handmade flutes or more or less small sound quasi The other is high.

Those who have learned the flute know that there are two verses of the flute. Generally, the flute in the two quarters adapts to various situations in order to facilitate the mediation high, and the flute will make the flute the intention to make a little bit higher, so that the performers can adjust the sound height by themselves. The two sections of flutes can fine -tune the sound of the activity sleeve or indentation. If the tone is high, pull out a little, and the low will shrink a little. (Two sections of flute initially invented for the band's ensemble convenience)

If it is a whole flute, the more the flute is closer to the tone, the higher the tone. (It is recommended to use it with caution because of the need to adjust the flute to a certain amount of technology.) But generally a whole flute is suitable for solo, the overall or lower is basically not heard.

3. The flute is accurate as a whole, but the relationship between individual interval is not accurate

This type is also very common, such as: 12 or 34 is not allowed. In this case, the flutes of each taste will appear, but the problem of the probability is. The solution is to make an article on the flute hole. This is best to find a professional flute master to help. Generally, it is not easy to repair, because the flute has been fixed, eight -degree with plug position, inner bore diameter, open hole size, and opening distance. These conditions are closely related. coming. Therefore, in the basic stage of the producer, the production of bamboo materials, years, wall thickness, and diameter of the boring is fully considered. After adjusting eight degrees, if this stage is over, it is basically difficult to make perfection.